Overview
It is designed to program CPLDs and FPGAs from Altera only. It allows JTAG connectivity of any target device voltage from +1.2V to +5V. The Altera JTAG Blaster is compatible with Windows PCs Only. It is not compatible with Linux.
This device connects to an open USB port on a Windows PC and allows the Quartus Programmer application to directly program Altera devices. Installation of the EPT-JTAG-Blaster Driver is required for this device.
The driver provided by Terranologic allows this board to be used by the Quartus Application Programmer. Once this driver has been successfully installed, the device can be found in the Hardware Setup drop down box. Just select the device and the programming mode and the appropriate programming file and the board will program your device.
Specifications
- Programs Altera MAX II, MAX V, MAX10, Cyclone IV, Cyclone V, Stratix IV, Stratix V devices
- Programs JTAG, AS and PS modes
- Works with SignalTap II Logic Analyzer
- 10 pin header with Altera Standard pinout
- Connect LED indicates USB Enumeration
- Ultra Small footprint
- Micro B USB connector
- Multivolt I/O operation from +1.2V to +5V
The 5×2 connector has the same pinout as Altera Blasters.
| 85-000012 | EPT JTAG Blaster User Manual | EPT_JTAG_BLASTER_UM.pdf |
| 95-000013 | EPT JTAG Blaster Data Sheet | ALTERA_JTAG_BLASTER_DS.pdf |
| 45-000013 | EPT JTAG Blaster Project DVD | JTAG_BLASTER_GETTING_STARTED_GUIDE.pdf |
| 55-000013 | EPT JTAG Blaster Schematics | EPT_2232H_SP_S1_V2_SCH.pdf |
| 35-000013 | EPT JTAG Blaster Driver | jtag_hw_mbftdi_blaster64.dll |
